Murray Woods 412M 4-Head Planer Matcher 24" Wide x 6" Start Price USD 2,500.00 Current Price USD 2,500.00 Time Left - Bid Count 0 Buy It Now Price - Reserve Price - Start Time Wednesday, November 19, 2008 End Time Friday, December 19, 2008 Location Astoria, New York See more about 'Murray Woods 412M 4-Head Planer Matcher 24" Wide x 6"' Description This is a Murray/Woods # 412M maximum 6" height by 24" wide 4-head planer/matcher.   6-knife round heads.  Though believed to be operational, this machine has not been used in many years. Machine has pocket heads, takes 90 degree corrugated back, 1/4" or 5/16" steel.  Same as the Woods moulders. There is a motor control panel included.  Horsepower of motors estimated at 50hp top and bottom, sides 20hp each.  Cutterheads for side heads included and a few spares.  Spindles spun by hand and there were no incidences of bearing bumps.  No feed motor.  Uses 220 volts AC 3-phase power. See our other auctions and eBay store for a wide selection of other professional used woodworking equipment, including a complete set of knives for over 1,400 moulding patterns for Weinig moulders. Customer purchasing this item must contact us within 24 hours of the end of the listing and payment must be received in full within three days of the end of the listing or the item will be re-listed.  Deposits by PayPal OK; certified check, money order or wire transfer of funds are accepted payment types. This product is sold F.O.B. Astoria, New York 11102.  Customer arranges for freight or we can do so for a nominal fee; please contact us.  Customer pays all shipping charges.  Pickups at our Astoria warehouse are only made by appointment.  This is a very large machine - a rigger's services will be required to move it and load it on a truck.  Customer arranges for the rigger's services - we can recommend a local firm or use your own. All machinery is operational unless otherwise stated; however, all products are sold “as-is” and no warranties of merchantibility or fitness for a particular purpose are provided.  As this equipment is older, we make no representation concerning the machine's conformance with modern safety codes.  JRC Lumber assumes no responsibility for modification of the machinery to conform with any safety regulations; this responsibility is assumed by the purchaser.  If you would like to inspect this machine, let us know and we will be pleased to arrange an appointment for you in our Astoria warehouse.  Cosmetic surface rust should be expected on all machinery.  We will prepare all machinery $5,000 or above for you by removing the cosmetic rust from operational surfaces at no extra fee.  Training is strongly recommended for millwork machinery.  We would be pleased to recommend an independent third party for training and installation.  Call us at 1-800-693-1663 for more information. JRC Lumber Corp.  A family business in New York since 1892. Place a Bid!